Working with Resin

It has been so hot and humid here I haven't felt like posting much lately. It figures the PC would be in the hottest room in the house!

I'd like to take this opportunity to welcome the new followers of my blog and to thank the folks that have expressed an interest in the skull giveaway. The giveaway will close the end of July so if anyone wants in there is still time.

Recently I have been working on making the cavern I blogged about awhile back. The interior will have a curved ceiling. I needed to construct the ceiling light yet strong. I chose to build the foundation of the ceiling with resin.

I decided to move my entire operation outdoors into the garage for two reasons. First off the resin fumes are murder and I've yet to find a respirator mask that 100% blocks the odor. Secondly I figured it would be easier to load the finished piece in my clients truck straight from the garage.

The resin I am using is from WASCO -- Wildlife Artist Supply Company . It is a good product and the staff at Wasco are friendly and helpful should you need help with using any of their products.

The interior of the cave is roughed out in rigid styrofoam board. When it is completed it fits into a wooden framework that supports it. For the ceiling I stapled the middle of a piece of hardware cloth 1/4" screen to a panel of wood. Wood was also added to the end sections of the screen.

I curved the ends of the screen into the shape I wanted and secured the ends to my styrofoam boards. Next I hot glued sections of styrofoam to the screen. When I was done I roughed up the styrofoam with a coarse file so it looked irregular.

Resin time! I make it a habit of recording the dates I use the resin on a sheet of paper affixed to the can.

Older resin may not set up as readily as new material does. For this reason I always mix two test batches of the resin I plan to use.

One batch is allowed to cure in the paper cup. The other is applied to scrap pieces of the materials I will be using. This way if there is a negative reaction I can more readily figure out where the problem arose from.

In the photo you can see that the two small pieces of craft styrofoam are unaffected by the resin. While the piece of styrofoam insulation board is completely eaten away by the resin!

Once I knew I was good to go I began mixing up small batches of the resin with chopped fiberglas resin strands added to it. Not only does this thicken the resin it makes it incredibly strong.

I wrapped and taped a heavy duty black plastic garbage to the underside of my project to capture any resin drips.

In this photo most of the ceiling has been covered with the chopped fiberglas/resin concoction.

Once the resin is fully cured I can begin adding the rock look to the cavern ceiling. When I'm further along in the construction I'll post some pictures.

My Sculpture Featured on Etsy's Off the Beaten Path

It was a pleasant surprise to wake up to find my Sea Serpent sculpture had been chosen by the curator of Etsy Finds: Off the Beaten Path : Etsy Finds: Off the Beaten Path :: Etsy Blog .

I can't believe the number of people that have viewed it in a little over a day! Just goes to show you the power of the Internet.

I have another serpent in mind I'd like to create. This one will be "swimming" in resin water.

Creating resin water is a little more time consuming and the fumes are a bit much. For this reason I like to cast my resin pieces outdoors which means I'll have to wait for warmer weather to arrive.